So let us try to understand the first error that we have right to you already program your FPGA that
is downloaded a bit similar to an FPGA.
And then when you try to run a configuration that is your C program on to an FPGA, you are receiving
this error rate error while launching a program.
So app transaction error and the DPI statuses FC two zero zero zero zero zero to one right or you get
a memory rate error.
So these are the common form of an error that you get when you start working around with a new word.
OK, so let's try to understand why this error happened, right?
So there are multiple ways by which you could program and FPGA, OK, and that is handled by the German
GP, Facebook.
So you have a two jumping interface over here, one of them which is used to select the possible source
for your vote.
OK.
And either one is the programming interface that will be utilizing to program an FPGA.
Right?
So by default, it is on cue SBI.
OK.
So what that means is we have a programming flash which is built in self-test, OK, which we will be
executing.
So as you can take the power supply to a table.
We will be finding a program is executing OK or the series of peripherals will be automatically start
working.
OK.
And that is what we refer to as a built in cell test.
So we already have written a program, OK, which will trigger a benefit, and that will help us to
analyze whether all the peripherals are working on right.
So that is the program which is presented in the flash memory, OK, and to execute that will be finding
the programming interface that is selected by default.
This cue SBI.
Right?
And when we are performing and execution of the code, that is, we have returned to school and try
to execute on to an SPG here.
OK.
So we are basically utilizing a g tag interface, but we have not selected a du type word here, and
that is what is leading to this error.
That is a B transaction error.
OK.
So the simplest solution is to just bring out this jumper, OK, and added between the main connector
where geotech is reflected, right?
So here you can see the first two main header is for a sticker.
OK.
The second two main headers for us behind the last two mail here.
This will be for G8X.
Suggest they remove the jumper connector from here.
OK, and then you connected over here, and then you will be able to remove the Z.
Right.
So this will happen if you are utilizing your board for a first time.
So you brought the new book by default.
It will be on to s.p.a.
Just need to change the jumper to Jade A.