1
00:00:00,150 --> 00:00:04,920
So let us start working with an intermediate peripheral in this specific section, what are we going

2
00:00:04,920 --> 00:00:08,430
to target is the two you are late APIs that we have, right?

3
00:00:08,430 --> 00:00:10,710
So you say you are ClearType is very simple.

4
00:00:10,920 --> 00:00:14,580
So here immediately our focus will be on data transmission.

5
00:00:14,850 --> 00:00:21,210
OK, but when we consider the more advanced solution where we have the configuration available for you,

6
00:00:21,210 --> 00:00:21,860
what is you?

7
00:00:21,870 --> 00:00:23,330
What one six five five zero?

8
00:00:23,440 --> 00:00:23,570
Right.

9
00:00:23,580 --> 00:00:27,920
So there we need to configure different parameters.

10
00:00:27,930 --> 00:00:31,650
The operation went in which we want to operate our work.

11
00:00:32,370 --> 00:00:36,390
And then finally, we will be handling a little transmission, right?

12
00:00:36,600 --> 00:00:44,160
So when we consider an intermediate peripheral, so we need to focus on on multiple things, such as

13
00:00:44,460 --> 00:00:49,470
configuring the correct parameters, configuring the operation, the nature you want to operate, you

14
00:00:49,470 --> 00:00:50,070
are it.

15
00:00:50,340 --> 00:00:53,850
And then you could only proceed for the transmission rate.

16
00:00:54,090 --> 00:00:57,590
So let me just start working around it, then you are right.

17
00:00:57,630 --> 00:01:03,960
So utilizing the fundamental these'll script that we build up in the previous section, we created the

18
00:01:03,960 --> 00:01:05,320
fundamental basic right.

19
00:01:05,340 --> 00:01:07,260
So this is the only thing that is required.

20
00:01:07,620 --> 00:01:11,190
We will proceed to perform a validation of our design.

21
00:01:11,430 --> 00:01:16,530
So once validation is successful, we will be counting the number of tools that we have, right?

22
00:01:16,530 --> 00:01:19,740
So we are one, two and three ports available in our design.

23
00:01:19,980 --> 00:01:24,720
And if you go to a vote so you could see we have one check mark to check mark and three check.

24
00:01:25,130 --> 00:01:29,610
So this suggest that all the pools have been already mapped to their respective pin.

25
00:01:29,880 --> 00:01:34,110
So we proceed to generate an HDL wrapper to select and block design.

26
00:01:34,110 --> 00:01:40,770
Right click OK, click on Create Digital Rapid Rate that will allow water to automatically created Apatosaurus.

27
00:01:41,890 --> 00:01:47,070
So one to representation is successful, we proceed for generation of its.