Hello, in this tutorial, we will continue with the site.
But first of all, I will show you one more thing.
This is 10 seats connection.
One, two, three, four.
OK, and then the next, uh, ping starts with the nine.
OK, you can check the pin number ten high is one and nine, Kanavis two and, uh, ten and ten grand
is three and eleven.
OK, you can check this, uh, pin out also.
And now I will right here, for example, can open a test.
And then this is a service controller and the type is this one, and I will say just OK, and then what
are you going to do?
We're going to do, uh, we're going to create a bond program, OK?
And program area.
Right.
Click and new and the program zero.
It's a little diagram is OK.
And first of all, we will, uh, do one more thing.
We will start with the initialization of the ten line.
But we did a factory set to our server and we need to do and hardware configuration of our policy.
First of all, it's the hardware configuration of our Kalsi.
We need, uh, h w config software.
And at this point we will go, uh, we will go to an open area and we will select our spatial driver.
OK, we need to adapt our moderate and the address and everything and we will send it to p.l.c..
OK, this is our this is our hardware configuration and we need to go to set can uh, also now let's
take a look set can part working mode we can select from here or left.
Click to here.
OK, and now in general area we need to go to building telecommunication and we need to select the spatial
driver.
OK, and as remote OK.
And transport node I.D..
OK one and this can be OK.
And then for example in here I will select this five hundred k ok.
This is my can betray ok.
And these are all can believe it like that.
OK, and I will close it, I will just drill down on it, but first of all, we need to open our are
OK income.
We need to what we need to do Ethernet port, OK.
And this was I will search, but the Internet is disconnected, so we need to go to.
OK, this one, and I'm just looking.
Is it connected or not, my Ethernet cable.
OK, now it is connected and for the site checking, OK.
This site is also connected.
OK.
And I will search it.
And it is searching.
And OK, now, driver three is active and I will say just save driver, OK, we need to close it.
Why?
I will just save it, OK?
And I will close it.
Why?
Because in my, uh, program, OK, we need to select as communication settings.
OK.
Driver three OK, this is now selectable and HSW config again.
And it is opening.
Just focus and follow step by step.
When we try to do a download, it will be the driver because of a closet.
OK, and left click again to this CPU.
OK, one and five hundred K.
OK, now I will just do a download this system settings to my p.l.c..
Now it is downloading and I will say just yes and I will say yes, OK, this is downloaded and I will
say, just say and I will close it.
OK, now the site is OK.
And what we need to do, we need to do similar adaptations for self-drive site.
OK, for this tutorial.
I finished it.
See you in the next tutorial.