1
00:00:12,510 --> 00:00:19,770
Hello, in this tutorial, we will learn how to move factories, etc. try because we will build our

2
00:00:20,220 --> 00:00:23,440
system configuration from the beginning, OK?

3
00:00:23,610 --> 00:00:26,460
We need to go to parameters, function and parameters.

4
00:00:26,460 --> 00:00:33,180
Editor OK, and parameter to OK, we need to go to parameter two point zero eight.

5
00:00:33,390 --> 00:00:36,310
This is, um, the factory settings, OK.

6
00:00:36,450 --> 00:00:42,230
And if I make this parameter value, OK, we can change parameters from here to for example ten.

7
00:00:42,480 --> 00:00:44,960
OK then it is reset.

8
00:00:44,970 --> 00:00:55,730
And then I saw in my uh Ceradyne OK on the Cape it uh it became a reset and then now it is reset it

9
00:00:55,890 --> 00:00:58,080
and I will adjust.

10
00:00:58,080 --> 00:01:06,540
You can see for example, um let's go to some parameters and I will check once one spatial parameters

11
00:01:06,540 --> 00:01:07,020
for you.

12
00:01:07,270 --> 00:01:11,260
Uh, for example, at this point, the communication address, OK.

13
00:01:11,550 --> 00:01:12,870
Now it is default.

14
00:01:12,870 --> 00:01:13,230
Okay.

15
00:01:13,440 --> 00:01:17,570
And you can see default and this is default and this is default and this is default.

16
00:01:17,580 --> 00:01:20,060
Okay, now it is reset it to factor setting.

17
00:01:20,190 --> 00:01:24,000
And now we will continue with the policy side for this tutorial.

18
00:01:24,000 --> 00:01:24,840
I am finished here.

19
00:01:24,960 --> 00:01:26,820
See you in the next tutorial.