Good morning, friends.
Today, I will tell you how to interface a relay module with the Nomaka.
So over here we have VXI means by firewall and this is ground and or here we are using to Gilpin's the
PIN number seven and number eight.
So on the relay module, we have Bordelais and over here we have another is ground and two and signals
from the Omegle.
Right now I'm using all digital pens.
You can operate using analog pen.
Also in the separate video, I will tell you or in the continuation of this, I will tell you how to
operate with Delphin and how to operate with analog.
So right now, I'm using the pen.
So first you just go to software part and over here you have to just open and over here you have to
select the component.
So in this case, my computer is seven and you have to just close.
And in this you have to just tape like this does signal because we have to generate a signal in this
case.
So just to connect this and I am making a copy of this because in this case, I have to generate all
those signals.
So as you see, I just connect these and I just take a simple Ed handler to handle the error and take
away loop for continuous rerouting of this continuous fighting, not reading in this case.
And over here you have to just select the PIN number.
So my PIN number is seven and over here you have to just select the value.
And over here again, the PIN number eight and I just take to push buttons to push button one and push
button two.
So here this is my relay one and this is my relay too.
OK, so you have to just arrange these.
Not like this.
Like this.
And here the PIN number seven goes to this and over here we have to control you.
And I just take two signals that the relays on or off.
OK, so over here, my relay one output and this is my relay to output of.
OK, so just connect these relay one is connected to this and two is connected to this control.
You minimize the space and when you hit on one button, so first you have to just install the interfacing
fired using maker hub.
So over here, as you see already, select the board next then.
Com for next.
Next activity.
Take hardly 30 seconds for interfacing file as you see, just finish this task.
And they don't run, but when I say don't run button.
And over here, I just right now boarded up entire on all of them on.
Oh so right now using this, you can operate these relays.
OK, so this is how you can interface a module with Ardino makeup.
So this is the switching of related to and this is the switching relay one.
So this is how you can generate multiple signals using Ardino Mega, as you see right now, both are
condition on relay do is on little one is also on as you see Allouni glow.
OK, so this is how you can interface a relay module with already know mega.
Thank you.